None of the combinations I've tried so far sounds bad, but I have some experimenting to do with the curtains in Dirac, to maybe limit the corrections to my room's transition freq, or 1kH, or some other value. I'm going to have to finagle the user trims In the HTP-1 to match the Dirac trims, and try it that way. 64MP + 8MP + 2MP + 2MP Rear Camera Setup, Sensor Sizes/Pixel Data: 1/1.73, 0.8um (64MP, Main) + 1/4. Dirac trimmed down my LCR and Subs about -15dB, to match my surrounds and tops, so the levels are not even close. Dirac Sound Effect, MT6359 Audio Decoding Chip. The problem is, though, that I can't just enable/disable Dirac for a nice A/B comparison. I'm currently running through some listening tests, comparing Dirac, PEQ, and clean, in the various combinations.
DIRAC LIVE THEATER SETUP GUIDE SOFTWARE
Wouldn't it be nice if REQ software checked its own results, and made further refinements with multiple iterations? Fortunately the HTP-1 has 16 bands of PEQ for each of the 16 channels.
They bear little resemblance to what I measure with REW after the Dirac cal. They did respond quickly to my first email, though.Īnd to echo what Kal Rubinson said, the "Corrected" graphs in Dirac are merely Predicted.
It's only been a day since I sent the data, but I haven't heard back yet. I've reached out to Dirac Support, and they requested my REW. One time it reversed the polarity of the Center channel and the Subs. In the new room, there doesn’t really seem to be an audible difference between using the amp and just using the receiver for power. My new theater room is 149 sq ft so I don’t need nearly that much power to get loud. I've run Dirac about five different times so far, and I don't always get the same results. Dirac Live with Bass Control sub integration Minus Setup may intimidate casual users No onscreen display THE VERDICT With support for all key immersive audio formats, 16-channel output, and Dirac Live room correction, the Monolith HTP-1 surround sound processor punches well above its price class. My then living room theater was about 600 sq ft so the amp made a huge difference. I swapped the sub polarities, and it solved the problem. I ran REW on the system after Dirac, and, sure enough, there was the huge notch in each speaker/sub FR at the crossover freq. The problem is, I think, that my Zaph Audio SB12.3 mains and ZD3C center have their tweeters and mids polarity reversed, due to a 2nd order crossover on the woofers. The subs run off of one output channel on the HTP-1 via a Y-splitter to two channels on the Monolith 7X amp. They're installed one above the other in the wall, so the distance to the MLP is the same. is an AVP or Audio Video Pre-Processor designed for use in home theaters.
I'm having an issue with Dirac 2.4 on my Monoprice HTP-1 inverting the phase of my two FI IB318 Infinite Baffle subs. Multiple Subwoofers and Dirac Live Bass Control.
0 kommentar(er)
